Teaque,

There's not much to say on this subject. Many have removed their rears and left their fronts on because their rigs are also daily drivers.

Until you try it yourself, it's almost no use asking how the rig will handle, etc. If you do try it, be sure to check just how much articulation you gain (measure it) and also keep in mind by removing it your suspension will be more complaint which may be another result you're after.

Myself I run w/out the rear sway bar. I used to run a set of quick disconnects for the rear but that ended in Moab 3 years ago when I pretzel'd the bar on a rock.

Since then, I've been w/out the rear bar but then again, I don't try to drive anywhere near as fast as a car when going on curves and am always drive alert to what's going on around me. That's no guaranty that nothing will happen but it's a "calculated risk" I'm willing to take.

Wheel back spacing... I should also point out that in most cases, tire sizes are increased when this is done and there have been substancial discussion as to whether the increase in height versus the increase in width raises the COG which is directly related to how safe the rig will be with the sway bars removed.

As was pointed out... [disclaimer on]There is a risk and liability involved for anyone who removes them so just bear that in mind if you remove yours.[disclaimer off]<img src="/forums/images/graemlins/kewl.gif" alt="" />


Off Roader
98 Montero with the Winter Package
89 Montero minty clean and reserved for overlanding trips or Cars and Coffee events
96SR (3.15:1 xcase, 35's) gone to the rust gods
96SR Build Up Thread
Old web page
Old web page