Well, I got the rebuilt calipers on last night but I think my disc's are going to need turned down. Rust build up on disc was just too much for old pads to clean up.
So, before I pull the front hubs can anyone tell me what kind of bolts hold the disc to the hub?....are they just your standard metric head bolt or do I need a special torx bit or socket?
I might get away with useing a 1 7/8 or 2'' socket in place of the 54mm required for the hub nuts.
Also my manual says to re-pack hub with 'MP grease'.....whats 'MP' stand for?
Thanks.

Mine- 95 T100 4X4
Wife- 97 Rav 4