Waiting...waiting...waiting........

I'll give them a call early next week. They did say it would be a couple of weeks untill their engineers can strip it down. I did not get to go looking for a Zook shaft to drop into them (O/time at work), I will try again next week (5 days off, should be plenty of time to get it moving again.)

Did you find out the measurements of the bearings (internal dia, external dia, length, anything else of interest)???

Any more accurate rear 28 spline dimensions ( to decimals of a mm)?? No point going to ARB with "abouts" as dimensions for spline dimensions, as previously discussed.