I'm actually thinking of going on a junkyard trip to look for a 4L60 - working or not it will give me the part's needed to check for things like torque converter fitment, starter-bellhousing clearance, etc.

The speed sensor was mentioned because at this point, if I can't keep the transfer-case (and the before mentioned speed sensor) then I'll put in another 4L30E - that is the line that makes this swap not worthwhile at this point. The engine will run just fine with the TCM disconnected, and if I can keep the t-case and install a 4L60 - and the throttle cable/TCC switch I won't have to touch the 3.2l engine wiring.

I'm looking at swapping because in as much as it can make sense for a driveline to have a fuse, having a $2,000 fuse that can't be purchased at an auto parts store in the middle of nowhere (after towing the truck out of the woods) isn't a good thing. With the stock 3.2, I'm not worried about destroying a 700R4 or 4L60.

Maybe I should just install another 4l30e and learn to drive slower, but even at 55mph the trucks pass me smile

I plan on budgeting 2x the expected amount for this swap, with the expectation that I could very easily have to spend another $1k getting the transmission rebuilt if I go used. That's one reason why I'd like to find one out of a 2.8l 4x4 Blazer or S10: low horsepower and low weight, compared to what this tranny is rated at.

-Tad


1994 Trooper. 3.2 DOHC/auto. 4.77s,3xARB, OME 919HD springs. 34" Swamper LTBs
2001 Trooper "stock" <img src="/forums/images/graemlins/wink.gif" alt="" />
http://www.planetisuzoo.com