Quote

Quote

The speed sensor was mentioned because at this point, if I can't keep the transfer-case (and the before mentioned speed sensor) then I'll put in another 4L30E - that is the line that makes this swap not worthwhile at this point.


I guess I just don't understand this. You're letting the entire swap hinge on a speed sensor? That is a minor issue and should be among the least of your worries when you're talking about a tranny / driveline swap. There are much larger fish to fry doing this kind of work. If you can pull off the rest of the swap, the sensor issue will be easy to figure out.

There are a multitude of signal converters out there that should work for you if the signal needs to be modified. The Dana 300 (if you go that route) is not exactly a rare t-case swap. Plenty of folks use it with EFI motors that need a speed sensor input. It's a problem that's already been solved, you just need to pick the one that's right for you.

--Dan


It's more of if I have to go that far, it probably isn't worth it for me. I don't think that I'm generally very hard on things. I may be jinxing myself here, but I run 33s and lockers and haven't ever broken a tie-rod adjuster or CV.

I mean yes, I can get a dana 300 and a 4L60 and some flanges from an early Rodeo D44, but then I need to start over with driveshafts, shifters, crossmembers, exhaust, and then the speed sensor issue.

So, lets assume that I can find a transmission for $400. Maybe even at our pick-n-pull $20 rate if I'm lucky (and at that rate I'd better buy 3 and hope to get one good one).
A used dana 300 is going to be what, $100? 200?
The dana 300 to 4l60 kit from Novak is $525. - that includes a speed sensor and tone ring.
The speed sensor box that *should* let me use that speed sensor with the Isuzu ecu/speedometer is going to be around $100. - this is the big experiment
Then two dana 44 flanges for $40 each, and two shortened driveshafts for $100 each.
Twin stick shifter: $100 (if I have to buy a shifter, I might as well get the twin)

We are now pushing $1500 to $2000.

Then it's back to making crossmembers, skid plates and linkages.

That cost though is certainly more appealing than spending $2500 to have this transmission rebuilt. (That's the number on the receipt that I inherited from the previous owner - a mere 50k miles ago).

Maybe if I can start finding some deals on some of these things this can become a reality. I'm almost worried now that I'll find a deal on another 4L30E...

-Tad


1994 Trooper. 3.2 DOHC/auto. 4.77s,3xARB, OME 919HD springs. 34" Swamper LTBs
2001 Trooper "stock" <img src="/forums/images/graemlins/wink.gif" alt="" />
http://www.planetisuzoo.com