for a Dana60 or 9" it is going to be a job or lots of $$$s. The axles will have to be narrowed, most likely you could match up a gear ratio but it really isnt going to matter because its going to have to be pulled apart to narrow it anyway.

To find something with your current gear ratio I would look for a Wagoneer 44 that is a little wider and has disk brakes. Common ratios here are 3.73. This is probably the easiest option.

If you were willing to regear the front as well you could find an isuzu 44 with a G80 (chevy/GM) limited slip for pretty cheap. This would be a great width but the gears would be either 4.10 or 4.30. Which wouldnt be bad if you could find a Dana30 from a 4cylinder Wrangler with the 4.10 gears. You could be out the door with lower gears and a limited slip for less than a grand if you went with this route with disk brakes as well.


95 Rodeo LS, Auto, SAS, , 60 front, 14 bolt rear. 5.13 r&p, Hydro-Assist, teras..
http://www.pieceofhud.com/gallery