|
|
|
|
 Vent selector problems\new to the board
#521547
11/03/04 03:49 PM
|
Joined: Aug 2004
Posts: 20
OP
Need a Spot
|
OK I am done lurking and ready to post. I had been hanging out here toyota truck page But once I got the T100 they sent me over here. So far I have found lots of good tips for common problems, hood vibration, rattle ect. My problem is that the vent selector will not let me slide the lever all of the way over to the "vent" only postion. I can only get it to the vent\floor position. I am I by myself or is this another common problem?
89 ext cab 22re 4x4 267K miles (for sale)
94 Land Cruiser Factory lockers
95 T100 4x4 ext cab
|
|
 Re: Vent selector problems\new to the board
[Re: CMH]
#521548
11/05/04 04:48 PM
|
Joined: Aug 2003
Posts: 676
Rock Warrior
|
It just a simple cable control that runs this. I would check for either a kinked cable, the jacket over the cable not being secured so the whole assembly is shifting, or something jamming up at the other end of the cable. The dash stuff all pops off so you can watch the lever and cable when you move it to see what is going on. After that it's dash diving time.
1997 T-100 4X4 Xcab,Warn Hubs
02 Camry LE
2008 Yaris
|
|
|
|
|
|
OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.
PHP: 7.4.33 Page Time: 0.008s Queries: 15 (0.005s) Memory: 0.5867 MB (Peak: 0.6348 MB) Data Comp: Off Server Time: 2026-06-10 18:56:27 UTCValid HTML 5 and Valid CSS 