Extreme Terrain
4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums


Previous Thread
Next Thread
Print Thread
Rate Thread
Ignition Problem? #52399 05/17/03 08:31 PM
Joined: Feb 2002
Posts: 79
airfooter Offline OP
Getting the Wheeling Fever
I was on the way to work yesterday and my '84 4Runner quit. It had been running fine...
I put it on the trailer and brought it home. There is no spark. The cap and rotor are 2 months old and look great. There is 12+ volts at the coil when key is on. I did the "coil test" in the chiltons/haynes manuals and it did not look like there was any resistance across the coil. (they specify 0.4 to 0.5 ohms) So I bought a new coil. Still no spark. Parts store guy says igniter and pick-up coil are $300 each.

What should I check next?

Jason


1984 4Runner - V6 rear axle (locked by Lincoln), header, plenty of body cancer!
Waiting for install: x-over steering, dual 'cases, twin-stick, 3" body & drivetrain lift, rear springs up front
Still need: rear springs, 35" MT's, bumpers/sliders
2001 F350 - 7.3 110k miles on WVO conversion now!
Re: Ignition Problem? #52400 05/17/03 11:58 PM
Joined: Aug 2001
Posts: 2,941
DRTDEVL Offline
J
Roll Me Over
*****
Check another parts store! $300.00 for a "pickup???" <img border="0" title="" alt="[Eek!]" src="images/icons/shocked.gif" /> They are out of their mind. I am more than willing to bet the "pickup" went south, and you can "pickup" one for next to nothing from a boneyard. Heck, you can "pickup" an entire distributor with "pickup" in it for less than $50.


"A young man who does not have what it takes to perform military service is not likely to have what it takes to make a living." - John F. Kennedy

Proud owner of an 88 Montero (with a blown engine).
Re: Ignition Problem? #52401 05/18/03 02:18 AM
Joined: Feb 2002
Posts: 79
airfooter Offline OP
Getting the Wheeling Fever
yes, I wondered how much an aftermarket dist. was... is the pickup a common demon? is there a way to test it or the igniter?

Jason


1984 4Runner - V6 rear axle (locked by Lincoln), header, plenty of body cancer!
Waiting for install: x-over steering, dual 'cases, twin-stick, 3" body & drivetrain lift, rear springs up front
Still need: rear springs, 35" MT's, bumpers/sliders
2001 F350 - 7.3 110k miles on WVO conversion now!
Re: Ignition Problem? #52402 05/18/03 11:26 AM
Joined: Aug 2000
Posts: 244
RAZZMATAZ Offline
Wheeler
Jason, You could have possable broke the timing chain. Take off the dist cap and have a buddy turn the igniton key and crank her over a few times while you watch the rotor. I think it sould be turning cw when looking at if from the driver fender.. If the roter is not turning your timing chain has failed <img border="0" title="" alt="[Frown]" src="images/icons/frown.gif" />

HTH,
RAZZ


87 4Runner 22R-TE
4 Pro Comp IFS
63 Chevy springs
5.71 gears
Detroit in rear, Lockright in front
35 MT/R
Rancho 9000
Jacobs ProStreet ign module and Ultra coil
1992 3VZ-E swapped in
Re: Ignition Problem? #52403 05/18/03 04:32 PM
Joined: Feb 2002
Posts: 79
airfooter Offline OP
Getting the Wheeling Fever
Razz, Rotor still turns... timing set only has about 15k miles. Anybody know how to test the pickup or igniter? thanks y'all

Jason


1984 4Runner - V6 rear axle (locked by Lincoln), header, plenty of body cancer!
Waiting for install: x-over steering, dual 'cases, twin-stick, 3" body & drivetrain lift, rear springs up front
Still need: rear springs, 35" MT's, bumpers/sliders
2001 F350 - 7.3 110k miles on WVO conversion now!
Re: Ignition Problem? #52404 05/18/03 08:25 PM
Joined: Apr 2002
Posts: 5,688
Esquire812 Offline
Trail Leader
Test the pickup by sticking the probes of an ohm meter into the slots, you should get a reading of like 140-180 ohms. Thats the range specified for my 88' anyways...yup just checkd the book, 82-84 and 88 140-180 ohms. air gap should be set to between .008 and .016 for all models through 88'.
Most parts places around here tell me the pickup is non replaceable and an integrated part of the distributor...let alone "no longer available". I laughed at the Schucks counter man and went home where I propmptly ordered one from RockAuto on the east coast. Problem solved.
There really isnt anyway to test the igniter that I am aware of. Generally they work one minute and are gone the next with no in-between. Find somebody with a similar ignition as yours and buy them a beer for letting you try their igniter on your system. If it works then buy one. If it dont then you just saved yourself some serious $$$. I hate people that throw parts at a problem...if they are so willing to throw their hardearned away...I'll give them my address. Did you bother checking all your fuses? Incab and engine compartment?
~Darin <img border="0" alt="[Baby]" title="" src="graemlins/baby.gif" />


88' 4x4 *22R-EB Gen II*
87' $Runner *22R-EB Gen I*
85' Sillyca 22R-Esq

"I LIVE IN MY OWN WORLD...THEY KNOW ME WELL THERE"

Moderated by  4Crawler, 4x4Wire, kewlynx 







4x4Wire Social:

| 4x4Wire on FaceBook |


OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

Powered by UBB.threads™ PHP Forum Software 7.7.3
(Release build 20190728)
PHP: 7.4.33 Page Time: 0.015s Queries: 14 (0.012s) Memory: 0.6108 MB (Peak: 0.6955 MB) Data Comp: Off Server Time: 2026-11-18 05:00:15 UTC
Valid HTML 5 and Valid CSS