Got R done!

I had them in upside down. The lift block goes tapered side up and fits up into the body, then the rubber bushing sits between the lift block and frame mount. Seems so simple now. it was still a tight fit. Cranked them all down the same.

And my nuts are 22 mm. If any of you do this make sure you check before you purchase a socket. Most standard set only go uo to 20 mm. It could be 20, 21 or 22. and you definitely need a deep well.

Now on to the spring lift. Gonna work on that this week. I will post some pictures when I get done.

Thanks for the help!