Gotta run out in the garage and grab it... I know those pages are kinda greasy... back in a bit...

Edit: Okay, here it is: bearing cap bolt: 55-61 ft/lbs.

Oh, in the "service points of reassembly" they want the following tightening sequence:
From the front of the engine there are eight bolts... They are in this order: (picture the front of the engine being at the bottom of the *picture*

(back of engine)

5---------6

1---------2

4---------3

8---------7

(front, timing belt side)

Tighten in the order of the bolts, 1 first then 2, etc. Oh, then "check that the crankshaft turns smoothly." I think you 've got that one already, eh? <img src="/forums/images/graemlins/wink.gif" alt="" />

Good luck!

PHIL