So now it looks like:
Phase 1- R151, and new 23 spline input for the front tcase. Freshen as needed.
Phase 2- 23 spline for the rear, and 23 spline adapter for the MC. Mebbe throw in that trick AllPro output shaft, the one without the groove that has been known to snap. Let stand until wallet recovers.
Phase 3- inherit boku bucks. Hey, I can hope. I have no more living relatives though, much less with money. Maybe I can borrow one.
Phase 4- pick up a Taco or Runner with flat-taco-itis but no engine damage. Pick up a harness from Mike Caskey. Pick up a radiator. Pick up a V6 bellhousing. Figure out a clutch. Relocate the motor mounts. What am I forgetting?

<small>[ June 30, 2003, 07:08 PM: Message edited by: Bill_Morgan ]</small>