|
|
|
|
 Re: new head - engine not running right
[Re: swamprocket]
#579810
03/17/05 08:46 PM
|
Joined: Dec 2004
Posts: 221
Wheeler
|
double check your spark plug wires.... and make sure your thermostat isnt in backwards. Its always the easy things that get over-looked. Running a tap down your head bolt holes will insure proper torque.
|
|
|
Re: new head - engine not running right
#579811
03/18/05 12:11 AM
|
|
Anonymous
Unregistered
|
The way I burp my 22re is:
park with front slightly higher than rear
top off rad with coolant
set heater control to hot
run with cap loose for awhile(may vary}
Keep an eye on the Temp gauge!!
the coolant may spillover once the thermostat opens
top off rad with coolant
allow thermostat to cycle a couple times
you can tell by looking at the coolant flow(cap off)
top radiator off and cap tight
fill over flow jug to "Hot" line
drive around the block
allow to cool then check coolant level.
done.................Karl
|
|
|
|
|
|
OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.
PHP: 7.4.33 Page Time: 0.007s Queries: 16 (0.005s) Memory: 0.5902 MB (Peak: 0.6568 MB) Data Comp: Off Server Time: 2026-06-17 21:38:24 UTCValid HTML 5 and Valid CSS 
