1st gen clutch release / slave cylinder stuck

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Re: 1st gen clutch release / slave cylinder stuck [Re: MeatWagon] #588140 04/03/05 07:28 AM

Joined: Apr 2000

Posts: 7,268

Ventura County

mlclark

Isuzu Moderator

If there is a nut, it will be on the other side of the tab on the engine. It should be pretty easy to see and or feel for if you are spinning that bolt. If that is not the case, then it is stripped and it is time to get out the cutting tools and pop that head off.

Michael

Entire Thread
Subject	Posted By	Posted
1st gen clutch release / slave cylinder stuck	MeatWagon	04/02/05 11:29 PM
Re: 1st gen clutch release / slave cylinder stuck	mlclark	04/03/05 07:28 AM
Re: 1st gen clutch release / slave cylinder stuck	Mike Bridges	04/03/05 01:09 PM
Re: 1st gen clutch release / slave cylinder stuck	TurtleDriver	04/03/05 04:27 PM

Moderated by 4x4Wire, houlster, jezeric, Jim_Paget, strawmyers

Hop To

4x4Wire Social:

| 4x4Wire on FaceBook |

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

PHP: 7.4.33 Page Time: 3.488s Queries: 16 (3.486s) Memory: 0.5991 MB (Peak: 0.6321 MB) Data Comp: Off Server Time: 2026-06-20 15:50:31 UTC
Valid HTML 5 and Valid CSS