1st gen clutch release / slave cylinder stuck

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Re: 1st gen clutch release / slave cylinder stuck [Re: MeatWagon] #588141 04/03/05 01:09 PM

Joined: Dec 2000

Posts: 186

Harriman TN USA

Mike Bridges Offline

Wheeler

You can pry the slave cylinder out(a little pressure) while loosening the bolt(air ratchet helps)and most will back out. If not as stated above use a dremel with cutoff wheel and cut the head of the bolt off. Goodluck

Entire Thread
Subject	Posted By	Posted
1st gen clutch release / slave cylinder stuck	MeatWagon	04/02/05 11:29 PM
Re: 1st gen clutch release / slave cylinder stuck	mlclark	04/03/05 07:28 AM
Re: 1st gen clutch release / slave cylinder stuck	Mike Bridges	04/03/05 01:09 PM
Re: 1st gen clutch release / slave cylinder stuck	TurtleDriver	04/03/05 04:27 PM

Moderated by 4x4Wire, houlster, jezeric, Jim_Paget, strawmyers

Hop To

4x4Wire Social:

| 4x4Wire on FaceBook |

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

PHP: 7.4.33 Page Time: 3.520s Queries: 16 (3.519s) Memory: 0.5984 MB (Peak: 0.6313 MB) Data Comp: Off Server Time: 2026-06-20 03:44:45 UTC
Valid HTML 5 and Valid CSS