1st gen clutch release / slave cylinder stuck

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Re: 1st gen clutch release / slave cylinder stuck [Re: MeatWagon] #588142 04/03/05 04:27 PM

Joined: Jan 2005

Posts: 22

TurtleDriver Offline

Need a Spot

The top bolt screws into the tranny case, the bottom one has a nut. I just did my clutch and the top one was stripped at the head. You can take the tranny out with the cylinder attached but it will make bleeding a bit more difficult after the fact. That is what I had to do.
Mark

Entire Thread
Subject	Posted By	Posted
1st gen clutch release / slave cylinder stuck	MeatWagon	04/02/05 11:29 PM
Re: 1st gen clutch release / slave cylinder stuck	mlclark	04/03/05 07:28 AM
Re: 1st gen clutch release / slave cylinder stuck	Mike Bridges	04/03/05 01:09 PM
Re: 1st gen clutch release / slave cylinder stuck	TurtleDriver	04/03/05 04:27 PM

Moderated by 4x4Wire, houlster, jezeric, Jim_Paget, strawmyers

Hop To

4x4Wire Social:

| 4x4Wire on FaceBook |

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

PHP: 7.4.33 Page Time: 3.503s Queries: 16 (3.501s) Memory: 0.5985 MB (Peak: 0.6315 MB) Data Comp: Off Server Time: 2026-06-20 08:23:26 UTC
Valid HTML 5 and Valid CSS