2.6l Isuzu Power

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

2.6l Isuzu Power #588776 04/04/05 10:52 PM

Joined: Aug 2003

Posts: 792

javven

Rock Warrior

Would it be possible to power a raider /swb monty gen1 with an Isuzu's later-model FI 4cyl?

Just how hard would this be? On the list so far are:

Install all isuzu's EFI stuff. If it was on the zoo, it must be on the monty.

Motor Swap.

Trans. *? not sure*

Engine itself,.more than likely.

Change your oil hot and often.
07 Taco V6 4WD 5-Auto

Entire Thread
Subject	Posted By	Posted
2.6l Isuzu Power	javven	04/04/05 10:52 PM
Re: 2.6l Isuzu Power	Kevin C	04/04/05 11:51 PM

Moderated by 4x4Wire, Macka, Mudraider, off-roader, PHIL_, rxinhed

Hop To

4x4Wire Social:

| 4x4Wire on FaceBook |

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

PHP: 7.4.33 Page Time: 3.622s Queries: 15 (3.620s) Memory: 0.5940 MB (Peak: 0.6270 MB) Data Comp: Off Server Time: 2026-06-09 18:23:08 UTC
Valid HTML 5 and Valid CSS