Thanks for the replies so far, especially Don who was on it straight away.

I have to move away from R12. I can get it, but it isn't the issue. I can no longer use it. I have to flush it out (if there's any left in there) and use something newer. I just wanted to know if the system has specific R12 components in it that must be swapped out. The fittings are a given. And what parts from later Isuzu's are an easy swap in.

I have never seen a Trooper of this vintage with 3 point restraints in the rear. There are either around-the-waist 2 point restraints across the rear (window, center, and window seats), or no restraints at all. I'm a member living in Japan, remember. What I was after was evidence that there were 3 point restraints somewhere (anywhere) and that there (therefore) might be anchor mounts already there in the piller for the above-the-shoulder bolt. Isuzu has this strange way of having every vehicle body made with all the possible mounts for any part. Of the same model and vintage, that is. Thanks for the info.

And, finally, I mean central locking doors. Not hubs. It's enough to be a nightmare. When you've never had it, you don't notice. When you are used to it, it's a real pain having to deal without it. In this case, it works and doesn't work in equal portions, and half the time it doesn't work the locks spring up sometime later to surprise you. Doesn't matter where you first unlock the car, driver's side, passenger side, or rear swing door. Always the same. It has just started doing it. Where is the central locking control? Is it something fouled with dust and grime? Is it an earth problem? Is there interference in any rod in any door doing it? Or is the central control unit ready for the bin? I'm just looking for a 'common fault' across the board, as a starting point of reference.

Cheers,

--Bighorn--