Head replacement (timing question)

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Re: Head replacement (timing question) [Re: steven c] #595050 04/21/05 03:08 PM

Anonymous

Unregistered

What I have heard and done, is rotate the crank until the timing mark comes up and the valves on the number one cylinder are closed and not moving. That is TDC. Then install the distributor with the rotor at the number one cylinder. HTH

Entire Thread
Subject	Posted By	Posted
Head replacement (timing question)	steven c	04/21/05 01:11 PM
Re: Head replacement (timing question)	Anonymous	04/21/05 03:08 PM
Re: Head replacement (timing question)	islandracer	04/21/05 03:54 PM

Moderated by 4x4Wire, houlster, jezeric, Jim_Paget, strawmyers

Hop To

4x4Wire Social:

| 4x4Wire on FaceBook |

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

PHP: 7.4.33 Page Time: 3.462s Queries: 16 (3.460s) Memory: 0.5927 MB (Peak: 0.6256 MB) Data Comp: Off Server Time: 2026-06-25 14:33:19 UTC
Valid HTML 5 and Valid CSS