Rear spring hanger dimension question - leaf swap

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Re: Rear spring hanger dimension question - leaf swap [Re: extremesolo] #597391 04/28/05 10:39 PM

Joined: Jan 2004

Posts: 912

Engineer

TheBandit

Rock Warrior

Make the hangers out of 1/4" thick 3.5" box tubing. That will give you the correct 3" inside dimension and the hanger will be beefy

[color:"darkgreen"]1986 4Runner - 4" IFS - 63" Chevys - 33" ATs - 5.29s - Rear Detroit
Sliders - Kayline - Rebuilt 22RE - On Board Air AND Factory AC
www.xtremefabricator.com[/color]

Entire Thread
Subject	Posted By	Posted
Rear spring hanger dimension question - leaf swap	extremesolo	04/27/05 06:33 PM
Re: Rear spring hanger dimension question - leaf swap	TheBandit	04/28/05 10:39 PM

Moderated by 4Crawler, 4x4Wire, kewlynx

Hop To

4x4Wire Social:

| 4x4Wire on FaceBook |

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

PHP: 7.4.33 Page Time: 3.489s Queries: 16 (3.487s) Memory: 0.5944 MB (Peak: 0.6273 MB) Data Comp: Off Server Time: 2026-06-23 19:50:53 UTC
Valid HTML 5 and Valid CSS