Thanks for the response Jerry. I measured the metal line and it was very close to 3/8". I was thinking of putting the sender manifold right where the metal and rubber lines join up near the radiator. I was going to use a 3/8" compression fitting on one side of the sending unit manifold (for the metal transmission line) and a 3/8" barbed hose fitting on the other (for the rubber hose line). I figured that this setup would help support the sending unit manifold since it is brass and a bit heavy. I may just splice into the rubber line like you suggested and put a barbed 3/8" fitting on both sides of the unit. If I do this, do I need to go with different rubber hose or can I just use what it already there? Thanks for the input!


You wouldn?t worry what people thought about you if you realized how little they did!
1988 Isuzu Trooper Limited, Bone Stock, 2.6L, 5 speed manual trany.
2001 Isuzu Trooper Limited, Bone Stock, 3.5L, Automatic.