AFAIK (and based on the 3.0L), the only way to really clean it thoroughly is to remove the plenum, take off all associated hardware (including plugs) and use a strong solvent like Berryman B-12. After the inside is completely clean, flush it with plain water and let it dry before reassembly.

I don't know if you have an air valve in the plenum, but if you do the solvent may eat any plastic or rubber shaft bushings - so if there's anything assembled within the plenum it should probably be removed before using any solvent.

There may be better solvents, but from experience I know that Berryman B-12 will do the job - but it does take several cans (maybe 6) and you need to do the job in an open space - preferably outdoors - as the fumes are powerful and harmful to your health.

B-12

Good luck,
Frank


'89 [color:"white"]G-Raider[color:"white"] [color:"black"]Supercharged 3.0L, MegaSquirt 2, lockup A/T, 2.5" exhaust, 172k, Cibie H4s/Oscar SCs, Hella Micro DE fogs, Cobra CB, Superwinch hubs, LSD rear/Aussie Locker front, Bilsteins, Lifeline AGM, Rust-Oleum