Thanks for all the advice guys. Well I finally got the hub off the spindle by cutting through the spindle and into the bearing and cutting everything into pieces. The spindle is shot obviously but I'll be ordering one of those shortly from Roger Brown. Think I'll be able to salvage the hub. But I did crack the rotor trying to press out spindle, so I'll get a good used one or a new one from NAPA. Guess I'll be keeping an eye on my bearings and watching my mud puddles a little more carefully. Thanks again for all the help.

1994 P'up, 22RE, K&N, LCE exhaust sys (header, cat, muffler, 2.25" pipe), 1" RB seat lift, 1" RB body lift, 1.5" rear lift via shackles, Rancho 5000's, 33" Pro Comp M/T's, 4.88's w/ Aussie lockers front & back