spent the last two weekends putting electricity in my garage but did get a little bit of work done on the Pup.


pulled the engine harness, threw some labels on the connectors as the whole thing is getting reworked


pulled the throttle body, here is the TPS. It's a drive-by-wire style and a servo gets its feedback from this TPS. I'm either going to convert this one to cable throttle or most likely see if the earlier TBs will bolt up. Definetly not going to convert my truck to drive by wire, haha.



most of harness


intake manifold




other side of throttle body. here is the servo motor.




I'm guessing this is the MAF.


Have no idea which sensor this is. Haven't found the wiring schematic for this engine yet.
[img]http://berisford.net/uploads/cpom/projectpup/3/img_0896.jpg[/img]
[img]http://berisford.net/uploads/cpom/projectpup/3/img_0897.jpg[/img]
[img]http://berisford.net/uploads/cpom/projectpup/3/img_0898.jpg[/img]

that mystery sensor plugs in to the lower left of these two ports. Other one is EGR.
[img]http://berisford.net/uploads/cpom/projectpup/3/img_0899.jpg[/img]

I really have some work to do.
[img]http://berisford.net/uploads/cpom/projectpup/3/img_0900.jpg[/img]

Oh no wait I really have some work to do.
[img]http://berisford.net/uploads/cpom/projectpup/3/img_0901.jpg[/img]

Not like I need to broaden the scope of this project any more than it already is, but I think I am going to build in a custom dash/display. here is just planning out what wires do what.
[img]http://berisford.net/uploads/cpom/projectpup/3/img_0902.jpg[/img]
[img]http://berisford.net/uploads/cpom/projectpup/3/img_0903.jpg[/img]