Quote
That is a good point about holding the nuts in. Maybe I will weld a 1/2" washer over the little tabs. Maybe some type of silicone sealer spread around there will just make the nuts stay put....


If you do that, you might want to put another couple of tabs on it so the nuts can't fall out the sides. 3 would have done it originally but now you need 4. Besides, the metal you're using isn't that thick so it doesn't get a big bite on the nuts. Maybe put 2 more thick tabs on each nut and weld your washer across the top of those???

Just kind of thinking out loud here...

Chris Enos (Chino, CA)

'91 Isuzu Amigo "Rover" (Camaro 3800 swap in progress / 2.25" exhaust)
....(SOA / Custom rear bumper / CB / HAM)