Started working on the electrical. I put all the relays and power distribution into a 8x16x2" aluminum project box that is getting mounted to my dash support bar. 4ga wire comes in off the battery which is mounted behind the driver's seat, to a 100amp auto reset breaker. Two mini-fuse blocks hold 20 fuses and tab mounted relays are in the upper right hand corner. I only need 3 relays so the rest are extras for now. The little bundles of wires are: always hot, hot in ACC and ON, and hot in ON and START.

I need 3 terminal post things or something to make them all connect to. I have a few screw-in type terminal strips and I was thinking of using one side to connect the wires, and the other I could piggy back every terminal together then only need one lead powering the strip. But in that situation, the terminal connected to the power lead would have to support all the power and these strips are only rated to 20A. Does anyone know of some thing that would work in this application?