The wires are a little fuzzy, however, the blades of grass came out nice and sharp <img src="/forums/images/graemlins/lol.gif" alt="" />


Give me a few and I'll round up the info on what pins go where. On the wires that look cut, they probably pulled out of the pin and the pin is sill in the connectors. Also, the 90 harness won't work. The '94 is a new harness. Some pins are likely the same, but may not be, and the colors I'm almost certain are different.

Replacing pins is easy, you just slide them in the back of the connector and they'll snap in place. Even being yanked out like that, they will still likely snap in OK.

If there are some pins still left in the connector that the wires broke off of, you'll need to remove them. On the other side of the connecter, pull the yellow plastic insert / pin stabalizer out. Just grab it with pliers and it pops straight out. Then use a small jewelers screwdriver to lift the locking clip (visible after taking the insert out) off the pin and push it out.

You can re-solder the wires to the pin for a quick repair, but you mentioned you had the other harness from a '90. You can still use one of those pins for a replacement. Clip it with 2" - 3" of wire still attached and splice it to your broken wire, then plug into your connector.

--Dan