Just to clarify a couple of things.
I can get every part no of 5.29's but I honestly don't recommend fitment to the Gen 1 4 cylinder front (7.25" diff).
My advice is to upgrade to the Gen 1 3.0 V6 front diff & CV's and use the 8" 5.29. Joe did this upgrade and used the 8" 5.29 for the front and rear now he can also run the new ARB front locker. You will have a much stronger front end as a result.
The small front 5.29 is a downgrade in strength and broken much easier than the 8" unit.
In fact over here no-one has actually managed to break a 8" 5.29 but plenty of the 7.25" have been.
The 7.25" is also more expensive than the 8" for some reason by about $70.
In terms of improvement you will notice it more onroad especially with an auto running 33"s which had 4.625 diffs.
It is a good upgrade as Lloyd said.
I noticed the difference in mine going up from 4.88's it improved onroad driveability but still doesn't substitute for lack of power running 35"s on a heavy lwb with a 3.0 V6. Offroad I did notice slightly deeper gearing in low range.
I can also say that the 8" 5.29 C&P is MUCH stronger than the Toyo version I have in the front of my truck with the SAS. The ring gear is way thicker along with the pinion gear. It would take something obscene to bust one of these <img src="/forums/images/graemlins/notooth.gif" alt="" />


I just luv my "clacker Jabber".................