Quote
hey bandit, what is that little tool called you used to measure out and draw where you were gonna cut? a protractor? where did you get it?


There are four pieces to that:
(1)Adjustable Square (Sears, ~$15)
(2)Block of PVC (I had it lying around, unneeded)
(3)Pencil
(4)Electrical tape

I used the block of PVC so the pencil would be rigid to the adjustable square, but you could do a pretty good job if you just wrapped tape around the pencil and "ruler" part of the adjustable square.

<img src="/forums/images/graemlins/cheers.gif" alt="" />

[color:"darkgreen"]1986 4Runner - 4" IFS - 63" Chevys - 33" ATs - 5.29s - Rear Detroit
Sliders - Kayline - Rebuilt 22RE - On Board Air AND Factory AC
www.xtremefabricator.com[/color]