I'll be doing this job shortly. The only way I can see to do this properly is to drop the pan and clean the screen, replace the lost fluid, take the truck to a shop and get the trans flushed. I'm guessing I'll need to take diamond ATF from Mistu with me as I doubt shops stock the right fluid.

On the other hand, with just over 100K miles on my truck should I expect the screen to be dirty/clogged? If not be may a flush in sufficient?

What's the general feeling on this?


'97 Montero 'LSR' - 4.6 gears & factory rear locker, 33" Procomp muds on 15x8 steelies, 50mm coil spacers, T-bar crank, Airlift, sans rear sway, 50mm rear frame & fuel tank lift, Aisins, ARB front bumper + 10k lb winch, 50mm DIY body lift, rock sliders, cut rear quarter panels...