I have flushed the fluid on my '03 by disconnecting the trans cooler tube. It is actually the method recommended in the FSM. I did not find it difficult and it was nice to know that I changed out almost all of the fluid. Most of the newer flush machines hook up to the cooler lines to make the process more convenient. However, it can easily be done by most shade tree mech's. Here is what I did.

1. Drive the car for about 20 min to get everything nice and warm.
2. Drain the fluid from the pan using the drain plug.
3. Replace the fluid that was drained. About 4 qts.
4. Disconnect the tube that connects to the lower end of the tranny cooler (on an '03 it is a little 4" long "U" tube)
5. Connect a piece of clear tubing and direct the flow into an bucket.
6. Run the truck for about 15-20 seconds. You will get about 2qts out. Then top up the tranny.
7. Repeat until you have gone through about 9-12 qts.
8. If you have a helper they can watch the fluid come out of the tube and when they start to see bubbles, you turn of the truck.

This method is described in my '03 FSM and I have seen it on many other forums.

I only used 10 qts. When I was done I did a blotter comparison between the old fluid, the new fluid from the bottle and the fluid in the tranny after flushing. While it did not match the pristine fluid from the bottle, it was very close. The old fluid in the tranny was very brown after only 30k.


'90 Montero XLS (Sold, sadly)
'95 Montero LS 160k
'03 Montero Limited 30k