The head bolts on your motor are not torque to yield so adding a bit more clamping load is not a problem.

TTY bolts typically have a very different tightening procedure where you turn them a number of degrees. Their strength is carefully controlled so that the clamping force is limited by them yielding. Once they have yielded the next yield point is not as predictable so to get a controlled clamping force you need to replace them after each usage.

The 3.0 bolts are the older style; use a torque wrench type. For these bolts its friction and thread pitch that control the clamping force at a given torque. Since the friction is a very large part of the equation (85% ++) and the actual force thatÆs left over is what gets used to provide clamping a small change in friction makes a big difference in clamping force.

ThatÆs why attention to the threads is important.

The Fellpro bolts should be fine.

Kevin


87 Turbo Intercooled Raider, roller cam, torsen rear diff, LSD front diff, lockup auto with modified converter, V6 brakes, low transfer case gears...