I've been told by MMC mechanics that head bolts on the 3.0L are not TTY bolts and that they routinely re-use them once if the engine didn't badly overheat. I don't know about the FelPro bolts, but they should be fine.
Although I used new head bolts on my rebuild, out of curiosity I measured the old ones against the OE new replacements. No stretch had occurred in the old ones. OE new head bolt length is 4.010" (as measured on the ones I have left over), but IIRC I think I ground mine to 3.998". If you ever try that, you have to grind VERY slowly so you don't lose the temper and the threads have to be wire-wheel brushed (maybe even chased) and cleaned so there's no drag. If you have enough clamping range there's no need to ever grind the bolt length - and preferable that you don't.
In your case, just torque the remaining 8 lb-ft in the same circular pattern as before, beginning with one of the center area bolts and going clockwise around the heads. I think I'd do it in 2 steps - 75 and 80 so you break the initial tension on the first pass and set the final torque on the second pass. Don't wait too long to re-torque or the lubricating value of the oil residue on the threads and under the bolt head may be lacking.
Frank
'89 [color:"white"]G-Raider[color:"white"] [color:"black"]Supercharged 3.0L, MegaSquirt 2, lockup A/T, 2.5" exhaust, 172k, Cibie H4s/Oscar SCs, Hella Micro DE fogs, Cobra CB, Superwinch hubs, LSD rear/Aussie Locker front, Bilsteins, Lifeline AGM, Rust-Oleum
|