Extreme Terrain
4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums


Previous Thread
Next Thread
Print Thread
Rate Thread
2.6 Flywheel #658891 10/23/05 04:20 AM
Joined: Oct 2005
Posts: 7
R
Rhino58 Offline OP
Need a Spot
Was wondering if anyone knows if a 240mm flywheel from a mitsubishi starion will bolt to my 85 Dodge D50 w/ 2.6 engine. Thanks All!

Re: 2.6 Flywheel [Re: Rhino58] #658892 10/23/05 12:14 PM
Joined: Jan 2001
Posts: 13,649
fasteddy Offline
Web Wheeler
*****
Yes, it fits just fine. I've done it before. Nice big hefty clutch you get that way, too, huh? I'd change the pilot bearing while I was there.


Not responsible for advice not taken...
Re: 2.6 Flywheel [Re: fasteddy] #658893 10/24/05 06:28 AM
Joined: Jan 2003
Posts: 1,741
powerRam50 Offline
Body Damage is Cool
eddy cind of mentioned it but you have to also run a starion clutch.but it all bolts up.


87 dodge power ram 50,35" tires,5 1/2" total lift,4.6 gears,lockers front and rear,Rancho RS5000's,custom front bumper,custom rock sliders,cct extended diff breathers,75 amp alt(40 amp stock),thorely header,K&N,wheeled hard...
Re: 2.6 Flywheel [Re: powerRam50] #658894 10/24/05 03:32 PM
Joined: Jan 2004
Posts: 2,413
dadrab Offline
Body Damage is Cool
You'll also notice that the Starion flywheel will have a hole in it for a locating pin. Don't panic, but that pin will not be on your crankshaft output. The bolt holes will line up though.


87 Montero, bought new, by me -
88/89 intercooled Starion Turbo engine-
with awesome audio.









4x4Wire Social:

| 4x4Wire on FaceBook |


OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

Powered by UBB.threads™ PHP Forum Software 7.7.3
(Release build 20190728)
PHP: 7.4.33 Page Time: 0.006s Queries: 15 (0.004s) Memory: 0.5994 MB (Peak: 0.6544 MB) Data Comp: Off Server Time: 2026-06-24 14:47:41 UTC
Valid HTML 5 and Valid CSS