Top mounts:

i sort of copied Rogers design (2 plates mounted to outside of the frame, & a 1" square tubing crossmember bolted to the side plates (sitting at the gap btwn the top of frame & under the bed with no body lift) with a 1.5 feet long/1.5" angle iron welded to the middle of the bar, with top shock holes drilled to the angle iron. )

"It lasts me 20000km b4 it snaps when i was in B.C. because I had too much weld on one end of the angle iron to the thin wall square bar. (Cracked around the weld from fatigue) ...Been repaired by plateing it & not putting too much weld "

Bottom mounts:
muffle clamps each side (left & right) to the rear axle housing with a 2"x4" plates mounted to it (each plates are drilled with 2 holes for muffle clamps bolts & the other one for lower shock mounts.) I'm really surprise how this is holding up after 30000km! It was just for a temporary setup until i fab a mounting bracket welded to rear axle, but that still haven't happen yet!)

<img src="/forums/images/graemlins/kewl.gif" alt="" />