How to remove 3rd gen limited flare/molding?

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Re: How to remove 3rd gen limited flare/molding? #66473 06/19/03 12:30 AM

Anonymous

Unregistered

I had a honda back in the day and I removed the molding on th efenders with a heat gun, then adhesive remover for the leftover goo. I think that would be how to get the strip off between the flare and the body panel. As for the flare itself, i dont know. I think they are just bolted on though. Why are you taking them off?

Entire Thread
Subject	Posted By	Posted
How to remove 3rd gen limited flare/molding?	cronustrd	06/17/03 10:05 PM
Re: How to remove 3rd gen limited flare/molding?	cronustrd	06/18/03 09:57 PM
Re: How to remove 3rd gen limited flare/molding?	Anonymous	06/19/03 12:30 AM
Re: How to remove 3rd gen limited flare/molding?	cronustrd	06/19/03 12:37 AM
Re: How to remove 3rd gen limited flare/molding?	FattyCBR	06/19/03 01:47 AM
Re: How to remove 3rd gen limited flare/molding?	Jeff the marmot	06/19/03 03:51 AM

Moderated by 4x4Wire, Adam F, Dandeman, kewlynx

Hop To

4x4Wire Social:

| 4x4Wire on FaceBook |

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

PHP: 7.4.33 Page Time: 3.498s Queries: 15 (3.496s) Memory: 0.6011 MB (Peak: 0.6340 MB) Data Comp: Off Server Time: 2026-06-19 17:30:12 UTC
Valid HTML 5 and Valid CSS