Well I thought it was the brakes. Pulled both front wheels. Brakes where done 6-7 months ago, but the front passenger inside pad was worn at the bottom. I changed the front pads, and found out the grinding is still there. It doesn't occur until I slow down to a near crawl. Then it sounds like I'm crushing rocks on my rotors. The sound will stay when I accelerate, but isn't as audible when I pick up speed. At slow speeds, I can hear it, but it's ridiculously loud when I use the brakes. When I had the wheel off, I didn't hear any noises when I spun the rotors/wheel.

I assume it's the bearings then? I've never encountered a worn bearing, so I didn't test for looseness when I had the wheels off. Is it something I can replace? I only have a "basic" mechanics set, but I found these instructions appear simple...

http://www.4x4wire.com/forums/showf...BB69&Number=546892&Forum


I assume I need a special tool to remove a lock nut ring? If I go to the local national parts chain, what exactly do I ask for? When I can remove the hub/rotor, what should I look for? Will it be quite obvious to see worn bearings? Are those bearings something I can pick up at the local parts store?

Thanks for any advice


'95 Montero SR 3.5L V6 DOHC