I reach in with a dremel to make the necessary width for the display. Dash removal came a couple/few months later when the heater core went south, so while I had it out, I put the reinforcement brackets in. The dash wasn't exactly loose, just wasn't as strong at that mounting point as it was from the factory.

Thanks for the compliment, I've been wanting to show off that install ever since I did it, just didn't figure there would be much interrest so kept my enthusiasm to myself. hehe

Chris Enos (Chino, CA)

'91 Isuzu Amigo "Rover" (Camaro 3800 swap in progress / 2.25" exhaust)
....(SOA / Custom rear bumper / CB / HAM)