from Napolean....


ok...I took some notes and I can make a pair of lower mounts that will work great....they will not be self capture because you say they seem to stay in place. It also probably means a coil compressor is not needed because the coil does not get lifted up and over the tall rubber bump stops. How about $60 to cover materials and shipping in the 48 states? But you must post pics of how it went.

made up 1 lower set for TJ coils.....any takers for these?. These took me over an hour in cut/clean/drill/weld. ZUK <img src="/forums/images/graemlins/kewl.gif" alt="" />

just an idea but it would be cool if you could combine them with a U-bolt flip kit that captures the spring. Might make for a really decient off-road/DD option for gen 1 runners and some trucks.

I'm sure you went over this earlier in this thread, but it's gotten to big to re-read casually. What is a Napco coil? -- Matt

Happy New Year Matt-
I'm calling this the Napo coil....a TJ coil slapped over the rubber snubber. It don't get any cheaper and easier than this The pic above with my black painted mounts allows the TJ coil a better fit. I can self-capture the bottom mount if needed too.

.
.
.
The ZUK coil are the dual red ones....or the center mounted single version <img src="/forums/images/graemlins/cheers.gif" alt="" />

OK.....I trimmed the corners and the lower mount will slip right in the middle of a "flip-over".....a bolt can secure it at each end(see the 5/16" drilled holes)

WOW! i dont check the board for a couple days and ive got a coil setup named after me, and ZUK has developed a lower coil mount and improved upon it!

i like it ZUK <img src="/forums/images/graemlins/kewl.gif" alt="" />

improved it more....and more.... <img src="/forums/images/graemlins/smile.gif" alt="" />



feel sorry for the dial up guys....wait a sec. I'm one of them <img src="/forums/images/graemlins/scared.gif" alt="" />

The middle set is heading to Kentucky....got 2 sets left for those with saggy Runners. <img src="/forums/images/graemlins/cheers.gif" alt="" /> Happy New Year. ZUK

Keeping the thread alive! My truck was "ZUKified" again today. Here's a before pic with my sagging "custom" leaf springs, part Toyota, part Mazda. Soft, and any weight in the rear, spare tire, tools, hi-lift, camp gear etc. throws the rear end down. Notice the springs almost reversed arched sitting static.



Here's ZUK under my truck (again) <img src="/forums/images/graemlins/wink.gif" alt="" />



After 4 hours. My u-bolt flip plates needed "un-modified", to re-modify for the spring captures.



Nice arch, 2" lift, super-smooth ride, like stock new, and I noticed alot less body roll in the corners.



This Sunday is a Crown King trail ride here, so we'll see how they do on a 3 1/2 trail. <img src="/forums/images/graemlins/kewl.gif" alt="" />

Keep you posted and I'll check back later.
Staceman