i did a clutch master on my 84 pickup a while back. it has been installed and adjusted, then bled thoughly. recently it seems its getting tough to put it into gear. the clutch has low miles on it, as that was installed during my recent motor swap. if i slow down with the clutch pressed it will go in and out of all the gears properly. if i release the clutch then push it in again, it will require a little playing to put it back into gear. the tranny makes no wierd noises. the strangest thing of all is, if i start the truck with the clutch depressd and in 1st gear, the motor cranks slower and when it starts it requires a little pull to get out of gear. its almost as if the clutch never disengages fully. what could it be? the tranny only has 130xxx on it and when i changed the gl4 in it it was clean.