Ditto eighty-eight. You can pop the bj's out with a hammer.
You'll want PB Blaster or Aerokroil to soak things if there's a lot of rust in those areas.
Antiseize compound for reassembly.
A good axle grease for the spindle needle bearings, esp if you like to go out into water crossings

Wire brush to clean up mating surfaces before reassembly
Bungy cord to support brake calipers
loctite for the caliper bolts
cotter keys as applicable; your replacement bj's may have nylock nuts instead of castle nuts

Special tools
pickle fork
torque wrench A MUST; you can rent one

Do a read, and take a couple notes.