Quote
but without an OE standard I'm shooting in the dark


0 to .0039" (0 to .1 mm) for the bearing spacer that lives near the speedometer drive gear according to the 1984 manual... (Edited to account for a misprint in the 84 manual).

Tighter is better, I dont think the gasket is going to compress 20% from a measurments taken with a caliper with a slight bit of pressure.

I would allow .001" for the gasket.... And the snap ring may just give that much <img src="/forums/images/graemlins/shiner.gif" alt="" />. That should get you close enough.

Kevin

Last edited by Kevin C; 01/11/06 08:53 AM.