Hey everyone.. Well It's snowing, and guess what. My warn hubs have starting giving me problems.. I just replaced the factory hubs with warn's in September of 2005. I use the 4x4 at least once a week in muddy fields and smaller mud holes and have never had any problems. Tonight I locked in the hubs due to the snow and the front end popped and I was down to 2 wheel drive. I found the problem to be the right hub. I took the hub apart and cleaned it (Not that it needed it), gave it a good once over (no problems found) and placed it back on. The 4 wheel drive worked.. Then again the pop and back to 2 wheel drive.. Then pop and 4 wheel drive, and pop 2 wheel drive...ect... Took the hub back off, took it apart and gave it a real good look.. Still did not see a problem.. Then I gave it up. I placed the factory hub that has been made full time locked in, back on the right front. And the 4x4 works fine.. What could be wrong with the warn hub.. Everything is moving as it should in the hub including the interior slide and the gear is not stripped.. Any ideas.. Thanks in advance Michael, from Kentucky..