OK, I got pretty close on the camber which was the most visually obvious problem & also corrected most of my pull to the left. Though I can't see anything obviously bent, the bolts point in pretty different directions now but they are square to the floor.

Now, the whole string measurement thing has got me puzzled.
Tape the string to the front tire & walk rearward. Got it. Now Measure what? Is a string just a straight edge for the outer surfaces of the front & rear wheels? So, if the outer surfaces of the rear wheel are lined up (both touching the string) and the back part of the front wheel is not touching the string I have toe out and need to adjust until both surfaces of the front touch the string. Is that it?

Without pictures I would have thought you were measuring string distance from front left to front right at the front and rear of the wheels & adjusting until the measurement was the same, or slightly less in the front. Is that where the 1/8" greater measurement comes in? <img src="/forums/images/graemlins/confused.gif" alt="" />


Sid


89 extra cab 4x4 3.0 5 spd, 216K
4.56, Supra LSD, Lock Rite