Quote

Mmmm. So you are saying you saw a tech making verticle adjustments as well as horizontal with the front & rear cams on the lower control arm? I did notice each cam made a semicircle arc, but wasnt' really paying attention for verticle movement. That would change the caster I assume.

I hope that is not true. If so that WOULD be the preverbial monkey balancing on the greased bowling ball adjustment and probably not within the realm of the home mechanic. <img src="/forums/images/graemlins/frown.gif" alt="" />


Yes, by adjusting the lower control arm bushing eccentrics, you adjust caster and chamber.

Turning the eccentrics in the same direction equally either clockwise or counter clockwise will move the lower ball joint in or out effecting the chamber setting.

Turning the eccentric cams in opposite directions one clockwise the other counter clockwise or vise versa will move the lower ball joint fore and aft effecting the caster setting.

The trick is to get the chamber and caster set, both by manipulating the eccentrics cams. With professional alignment equipment makes it an easy task to set both the camber/caster at the same time, But to do it with conventional means using a cheap simple alignment gauge that attaches to the wheel and then attempting to set the caster then the chamber separately is a tricky thing to do and making the right choice on which adjustment to manipulate to bring the camber readings into spec's while maintaining the caster setting is going to be a long trial and error task.

This is why they use wheel alignment tables so they can view caster, chamber, toe, thrust, and cross camber all reasonably easily.

Chucky MoMo <img src="/forums/images/graemlins/wink.gif" alt="" />