Quote
Does bringing the cam down vs. up also adjust the caster? It seems like it changes the elevation.


Well if you look at the lower control arm, you have 2 eccentric cams, 1 front and 1 rear. If you turn the rear one so it moves that bushing inwards and you turn the front so it moves that bushing outwards you now move the lower ball joint aft. then if you do the opposite you move the lower ball joint forward. This affects the caster setting, these 2 cam also adjust the camber by moving the front and rear lower control arm bushings in or out the same amount. you have to move the cam's in the right orientation to one another to get both the caster and camber set. <img src="/forums/images/graemlins/drunk.gif" alt="" />

You have to remember that the steering geometry is already designed into the front suspension, the adjustment eccentrics just allow for fine tuning as the rubber bushings settle and wear takes place and only take small adjustments to bring it back into spec's.

So as elripster mentioned if you can't get it into spec's with the eccentric's then something is badly worn or bent.

Discount tires got my 33's within factory spec's with room to spare.

If your having trouble turning the eccentrics you may have to pull each cam bolt and lightly grease just the bolt shaft and reassemble, but they are tough to turn especially when you have the weight of the vehicle on them, which is what you have to do. jacking up the wheels to make the adjustments is going to make it more difficult to get a stable reading.

I leave this kind of tedious work to the people that have the equipment to do the job.


Chucky MoMo <img src="/forums/images/graemlins/wink.gif" alt="" />