Awsome! (this is my 1st time using such a resource, being a non-tecno-sapien). But I em even more ignorant than that, I dont even have the bolt out yet. When I lean on the wrench (Dad's trusty 1/2 inch drive Craftsman rachet, non pneumatic garage hacker here) the engine turns over, (the manual says it must remain at top dead center, I tried stickin it in 1st gear but it still moves). I will be removing the timing belt to access the head. If I am too green for this website (most people seem to know a lot more than me) please let me know. Otherwise, I sure do appreciate the help! D