Motor Install Tips

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Re: Motor Install Tips #691512 01/31/06 06:53 AM

Joined: Oct 2005

Posts: 65

Utah

FarmerTed

Getting the Wheeling Fever

Sounds like the transmission input shaft is not lining up with the clutch disc. Did you use an alignment tool to align the clutch disc and pressure plate? Also make sure the trans is neutral so the input shaft can rotate to align the splines.

1994 4x4 22RE

Entire Thread
Subject	Posted By	Posted
Motor Install Tips	Anonymous	01/30/06 08:27 PM
Re: Motor Install Tips	mosk	01/30/06 08:34 PM
Re: Motor Install Tips	Buck	01/30/06 08:59 PM
Re: Motor Install Tips	Anonymous	01/30/06 10:56 PM
Re: Motor Install Tips	Andy	01/31/06 01:23 AM
Re: Motor Install Tips	Anonymous	01/31/06 06:36 AM
Re: Motor Install Tips	RatLabGuy	01/31/06 04:29 PM
Re: Motor Install Tips	FarmerTed	01/31/06 06:53 AM
Re: Motor Install Tips	87Toy4x4	01/31/06 01:15 PM
Re: Motor Install Tips	Anonymous	01/31/06 03:54 PM
Re: Motor Install Tips	Esquire812	01/31/06 08:19 PM
Re: Motor Install Tips	Anonymous	01/31/06 08:32 PM
Re: Motor Install Tips	Anonymous	01/31/06 10:27 PM
Re: Motor Install Tips	Anonymous	01/31/06 10:37 PM
Re: Motor Install Tips	vtown	02/01/06 12:50 AM
Re: Motor Install Tips	Anonymous	02/03/06 07:12 AM

Moderated by 4Crawler, 4x4Wire, kewlynx

Hop To

4x4Wire Social: