Leaf spring question

Print Thread

Rate Thread

Re: Leaf spring question [Re: mlclark] #692346 02/06/06 12:17 AM

Joined: Oct 2002

Posts: 2,285

Boston (roslindale)

CPOM

Body Damage is Cool

Do you own a grinder and some sanding wheels? A belt sander? I am just a newbie welder but I think you need to cut through the oxidation on the metal to get a good bond. Then again I have heard this is not as necessary with some stick electrodes, if you're using those .

Why not just get some angle shims for the axle to correct the angle and run the first setup?

CHRIS
98 Amigo, 92 Pup

need a pickup 1st gen fuel level sender

Entire Thread
Subject	Posted By	Posted
Leaf spring question	spacecab90	02/01/06 07:39 PM
Re: Leaf spring question	RobG	02/01/06 08:01 PM
Re: Leaf spring question	spacecab90	02/01/06 08:18 PM
Re: Leaf spring question	sweater	02/01/06 09:06 PM
Re: Leaf spring question	RobG	02/01/06 10:36 PM
Re: Leaf spring question	paulevans76	02/02/06 12:16 AM
Re: Leaf spring question	spacecab90	02/02/06 04:34 AM
Re: Leaf spring question	RobG	02/02/06 02:31 PM
Re: Leaf spring question	spacecab90	02/03/06 02:57 AM
Re: Leaf spring question	mlclark	02/03/06 04:49 AM
Re: Leaf spring question	spacecab90	02/03/06 04:39 PM
Re: Leaf spring question	spacecab90	02/05/06 10:05 PM
Re: Leaf spring question	mlclark	02/05/06 11:37 PM
Re: Leaf spring question	CPOM	02/06/06 12:17 AM
Re: Leaf spring question	spacecab90	02/06/06 01:56 AM
Re: Leaf spring question	randii	02/06/06 06:45 AM
Re: Leaf spring question	Eric Upchurch	02/07/06 11:59 PM
Re: Leaf spring question	randii	02/08/06 12:12 AM
Re: Leaf spring question	RobG	02/08/06 02:47 PM
1992 Rodeo 2wd Project	Anonymous	02/08/06 02:10 AM
Re: 1992 Rodeo 2wd Project	mlclark	02/08/06 05:35 AM

Moderated by 4x4Wire, houlster, jezeric, Jim_Paget, strawmyers

Hop To

4x4Wire Social: