Well there is one possibility that comes to mind after reading your post and the info on code 12 and reviewing an 86 wiring schematic.

Make sure that you have a good ground to the engine block. Since the knock sensor's body completes the signal path to ground (engine block).

Also I assume the knock sensor wire is the same or similar to the later years, where there's an inner conductor and then an outer braided shield wire.

The outer shield is connected on the ECU side "only", which the terminal it's connected to is a sensor ground, so make sure the ECU has a Good ground as well.

The inner conductor goes from the knock sensor terminal to the ECU's KNK input terminal. Double check for continuity while wiggling the wire around to verify that the wire isn't going open (broken wire) with the movement of the engine when it's running.

Otherwise you've covered all bases on the knock system

1)Wiring circuit
2)Knock Sensor
3)The ECU

You replaced all with known working units except the wiring!!!!

The only other possibility would be the igniter, but there's no reference to the igniter being involved in the knock system.

Chucky MoMo <img src="/forums/images/graemlins/wink.gif" alt="" />