ok Update
I checked the Temp sensor, Start Switch, and the CSI.
I could'nt get much of a reading from the CSI so I thought I was testing it incorrectly. I moved on to the Temp switch which was almost dead-on according to the temprature chart in the FSM (something like 2.7).
I then check the Start switch and same thing I cant get much of a reading. It's supposed to be in the 30's + depending on temp. an how you test. However, I could only seem to get a reading in the .0XX range, nothing over 1 ohm and the same for the CSI nothing over 1 ohm.
(I thought if a sensor or csi went bad they might read higher than normal, too many ohms.<img src="/forums/images/graemlins/confused.gif" alt="" /> am I wrong?)
anyway
So based on these tests would you conclude that both the CSI and the Start switch are in need of replacing?
Thanks again
Jed

EDIT: HOLY COW both of thoes look terribly expensive <img src="/forums/images/graemlins/baby.gif" alt="" /> <img src="/forums/images/graemlins/frown.gif" alt="" />